Many single-use plastic (SUP) options made of synthetic polymers, bio-based materials, and blends of both are available in the market and used in large quantities. The disintegration of eleven commercial SUP, marketed in Mexico as cups and plates, was investigated in an aerobic home compost environment at a laboratory scale over 180 days. An evaluation of chemical changes, surface morphology, and thermal and mechanical properties was conducted to ascertain the original composition of SUP and the progression of disintegration in samples that are challenging to clean from soil contamination. Furthermore, the impact of residual compost on barley (Hordeum vulgare) plant growth and its correlation with the leaching of heavy metals were explored. The bio-based SUP, but not those made of expanded polystyrene foam, showed a correlation between the disintegration degree (measured by weight loss into particles <2 mm) and a decrease in functional groups (observed by FT-IR), mechanical-thermal stability loss, and surface wear over disintegration time. For instance, the highest disintegration at 180 days was approximately 70 % for wheat bran and palm leaf plates, followed by wheat plates and cellulose-PLA cups (60 %). In addition to the components listed by the manufacturers, the FT-IR and DSC analysis revealed the presence of polyethylene and polypropylene in cellulose cups and sugarcane plates. These components, impede disintegration but contribute to preserving thermal resistance and hydrophobicity during utilization. Compost derived from expanded polystyrene foam SUP, with 90 days of disintegration, was rich in zinc and chromium and significantly decrease in the root length of the barley plant compared to the control. This demonstrates the necessity of considering the impact of the leaching of additives and secondary microplastics into the environment.

The fate of black biodegradable mulch film (MF) based on starch and poly(butylene-adipate-co-terephthalate)-co- terephthalate) (PBAT) in agricultural soil is investigated herein. Pristine (BIO-0) and UV-aged film samples (BIO-A192) were buried for 16 months at an experimental field in southern Italy. Visual, physical, chemical, morphological, and mechanical analyses were carried out before and after samples burial. Film residues in the form of macro- and microplastics in soil were analyzed at the end of the trial. Progressive deterioration of both pristine and UV-aged samples, with surface loss and alterations in mechanical properties, occurred from 42 days of burial. After 478 days, the apparent surface of BIO-0 and BIO-A192 films decreased by 57 % and 66 %, respectively. Burial determined a rapid depletion of starch from the polymeric blend, especially for the BIO-A192, while the degradation of the polyester phase was slower. Upon burial, an enrichment of aromatic moieties of PBAT in the film residues was observed, as well as microplastics release to soil. The analysis of the MF degradation products extracted from soil (0.006-0.008 % by mass in the soil samples) revealed the predominant presence of adipate moieties. After 478 days of burial, about 23 % and 17 % of the initial amount of BIO-0 and BIO-A192, respectively, were extracted from the soil. This comprehensive study underscores the complexity of biodegradation phenomena that involve the new generation of mulch films in the field. The different biodegradability of the polymeric components, the climate, and the soil conditions that did not strictly meet the parameters required for the standard test method devised for MFs, have significantly influenced their degradation rate. This finding further emphasizes the importance of implementing field experiments to accurately assess the real effects of biodegradable MFs on soil health and overall agroecosystem sustainability.