The wind resistance of transmission towers is not only affected by wind load, but also by service environment. This study uses the world's second Ultra High Voltage Direct Current transmission project - Xinjiang & PLUSMN;800 kV Tianzhong Line UHV DC transmission project - to develop a fragility analysis method for transmission towers in saline soil under wind loads to investigate the change of wind loads fragility of transmission towers in long-term service in the saline soil environment. It develops a tower-line-foundation (3 T-2L-F) system model considering soil-structure interaction. In addition, this research addresses the durability damage of the transmission tower using field investigation data and material degradation models and analyzes the influence of various durability damage components on the natural vibration mode of the basic of 3 T-2L-F model. Finally, it builds the structure-wind samples utilizing a Latin hypercube sampling method and explores the time histories analysis, the pushover analyses, and the time-varying fragility analyses considering the uncertainty of materials and wind loads. The findings indicate that the 3 T-2L-F model accurately simulates the actual situation of the transmission tower. The fragility of a transmission tower subjected to wind loads is proportional to the degree of material damage and the strength of wind loads.

This paper presents a comprehensive assessment of the accuracy of high-frequency (HF) earth meters in measuring the tower-footing ground resistance of transmission line structures, combining simulation and experimental results. The findings demonstrate that HF earth meters reliably estimate the harmonic grounding impedance (R25kHz) at their operating frequency, typically 25 kHz, for a wide range of soil resistivities and typical span lengths. For the analyzed tower geometries, the simulations indicate that accurate measurements are obtained for adjacent span lengths of approximately 300 m and 400 m, corresponding to configurations with one and two shield wires, respectively. Acceptable errors below 10% are observed for span lengths exceeding 200 m and 300 m under the same conditions. While the measured R25kHz does not directly represent the resistance at the industrial frequency, it provides a meaningful measure of the grounding system's impedance, enabling condition monitoring and the evaluation of seasonal or event-related impacts, such as damage after outages. Furthermore, the industrial frequency resistance can be estimated through an inversion process using an electromagnetic model and knowing the geometry of the grounding electrodes. Overall, the results suggest that HF earth meters, when correctly applied with the fall-of-potential method, offer a reliable means to assess the grounding response of high-voltage transmission line structures in most practical scenarios.

This study elucidates the findings of a computational investigation into the stimulation characteristics of natural reservoir systems enhanced by high-voltage electropulse-assisted fluid injection. The presented methodology delineates the comprehensive rock-fracturing process induced by electropulse and subsequent fluid injection, encompassing the discharge circuit, plasma channel formation, shockwave propagation, and hydro-mechanical response. A hydromechanical model incorporating an anisotropic plastic damage constitutive law, discrete fracture networks, and heterogeneous distribution is developed to represent the natural reservoir system. The results demonstrate that high-voltage electropulse effectively generates intricate fracture networks, significantly enhances the hydraulic properties of reservoir systems, and mitigates the adverse impact of ground stress on fracturing. The stimulationenhancing effect of electropulse is observed to intensify with increasing discharge voltage, with enhancements of 118.0%, 139.5%, and 169.0% corresponding to discharge voltages of 20 kV, 40 kV, and 60 kV, respectively. Additionally, a high-voltage electropulse with an initial voltage of U0 1/4 80 kV and capacitance C 1/4 5 mF has been shown to augment the efficiency of injection activation to approximately 201.1% compared to scenarios without electropulse. Under the influence of high-voltage electropulse, the fluid pressure distribution diverges from the conventional single direction of maximum stress, extending over larger areas. These innovative methods and findings hold potential implications for optimizing reservoir stimulation in geo-energy engineering. (c) 2025 Institute of Rock and Soil Mechanics, Chinese Academy of Sciences. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/ 4.0/).

Existing solutions for electro-osmotic consolidation assume a linear voltage distribution, which is inconsistent with the experimental findings. The present study introduces a novel two-dimensional electro-osmotic consolidation model for unsaturated soils, which considers the influence of non-linear voltage distribution. The closed-form solution is derived by employing the eigenfunction expansion method and the Laplace transform technique. The accuracy of the analytical solutions is validated through the implementation of finite element simulations. The findings from the parametric studies indicate that the excess pore water pressure (EPWP) observed in electro-osmotic consolidation is influenced by the distribution of voltage. The dissipation rate of EPWP is observed to be higher when subjected to non-linear voltage conditions compared to linear voltage conditions. Moreover, the impact of non-linear voltage distribution becomes more pronounced in unsaturated soil characterised by higher electro-osmosis conductivity and a lower ratio of kx/ky. In contrast, the excess pore air pressure (EPAP) remains unaffected by the voltage distribution.

Electrokinetic-Permeable Reaction Barrier (EK-PRB) coupled remediation technology can effectively treat heavy metal-contaminated soil near coal mines. This study was conducted on cadmium (Cd), a widely present element in the soil of the mining area. To investigate the impact of the voltage gradient on the remediation effect of EKPRB, the changes in current, power consumption, pH, and Cd concentration content during the macroscopic experiment were analyzed. A three-dimensional visualized kaolinite-heavy metal-water simulation system was constructed and combined with the Molecular Dynamics (MD) simulations to elucidate the migration mechanism and binding active sites of Cd on the kaolinite (001) crystalline surface at the microscopic scale. The results showed that the voltage gradient positively correlates with the current, power consumption, and Cd concentration during EK-PRB remediation, and the average removal efficiency increases non-linearly with increasing voltage gradient. Considering power consumption, average removal efficiency, and cost-effectiveness, the voltage range is between 1.5 and 3.0 V/cm, with 2.5 V/cm being the optimal value. The results of MD simulations and experiments correspond to each other. Cd2+ formed a highly stable adsorption structure in contrast to the Al-O sheet on the kaolinite (001) crystalline surface. The mean square displacement (MSD) curve of Cd2+ under the electric field exhibits anisotropy, the total diffusion coefficient DTotal increases and the Cd2+ migration rate accelerates. The electric field influences the microstructure of Cd2+ complexes. With the enhancement of the voltage gradient, the complexation between Cd2+ and water molecules is enhanced, and the interaction between Cd2+ and Cl- in solution is weakened.

The railway transport system is a key factor supporting industrialization in all aspects of human activity. However, in order not to lose its importance, it must meet the challenge of modern civilization. The safety, reliability, and efficiency of railway transport, to a large degree, depend on using highly integrated electronics, which are very sensitive to various disturbances generated in the electric traction system and train or coming from the environment. One of the sources of electromagnetic disturbances are high-voltage (HV) power lines running close to the railway infrastructure. The purpose was to assess the electromagnetic impact of overhead HV transmission lines on buried signaling cables of the railway traffic control system crossbreeding with them. The levels of voltage induced in the cable under steady state and the earth fault in the HV line at various soil resistivity were estimated. A software tool based on a hybrid numerical method that combines circuit theory and electromagnetic field theory was used for computations. It was found that very high voltages may be induced in the signaling cables during earth faults in the HV lines, which may lead to serious interference or damage to the equipment. The results provide useful knowledge for implementing modern railway traffic control systems and protection measures.

The induced voltage generated by lightning electromagnetic (EM) field often damages photovoltaic (PV) panels. To address this issue, a novel solar-cell string wiring is proposed. By the crossover connection of solar-cell strings, the induced voltages are offset by each other. The lightning EM transient of PV array installed on flat ground is computed by using the method of moments. Compared with the conventional wiring, the proposed wiring can not only reduce the induced voltages of most PV panels but also the voltage between the outputs of PV array. The proposed wiring is highly recommended to be used in the PV array on the soil with great resistivity. Moreover, the effect of the proposed solar-cell string wiring on rooftop PV array is assessed. The results indicate that the rooftop PV array with the proposed wiring has a minimum induced voltage. This novel solar-cell string wiring does not require additional protection devices and is easy to implement.

Over the past twenty years, there have been numerous instances of damage to the outer sheath of cables, the cause of which remains unknown. Surprisingly, some of these cables were not even in use at the time of the incidents. Most of the damages occurred in areas with a high frequency of lightning strikes. To address this issue, a research study is currently underway to examine the impact of direct lightning strikes on medium voltage cables and develop protective measures. As part of the study that is ongoing, we are developing a simulation model that takes into account factors such as soil ionization, lightning parameters, and moisture to mimic realistic lightning strikes on the ground. The main aim is to utilize the acquired knowledge to aid in selecting suitable cable design for future projects.