This paper presents the findings from a series of constant suction triaxial tests conducted on compacted sand and silty sand under unsaturated conditions. These tests were carried out using a fully automated double-walled triaxial cell employing the axis translation technique. The net mean stresses applied ranged from 50 to 250 kPa, while matric suctions were maintained at 0, 100, and 200 kPa. The primary objective of this study was to elucidate the mechanical behavior of the two compacted soils under triaxial conditions, particularly focusing on the influence of suction on variables such as peak stress, apparent cohesion, critical state stress, postpeak softening, and strain-induced dilatancy. The experimental results were utilized to calibrate and validate two prominent critical state-based models for unsaturated soils: the Barcelona basic model (BBM) and the Morvan model. While the BBM accurately predicted the deviatoric stress values at the critical state under controlled suction conditions, it did not adequately capture the postpeak softening behavior. Conversely, the Morvan model, after appropriate calibration and validation, successfully replicated both the critical state and postpeak behaviors, demonstrating a strong correlation between its predictions and the experimental data for both soil types.

Soil liquefaction caused by earthquakes is a devastating occurrence that can compromise the foundations of buildings and other structures, leading to considerable economic losses. Among the new remedies against liquefaction, Induced Partial Saturation (IPS) is regarded as one of the most promising technologies. In order to improve liquefaction resistance and the fluid phase's compressibility, gas or air bubbles are introduced into the pore water of sandy soils. This article deals with the general laboratory evaluation of a sand under partially saturated conditions and under cyclic loading to assess if this technology is applicable for a ground improvement of the examined soil. The use of the Axis Translation Technique for sample desaturation and diffusion-stable butyl membranes significantly influences the laboratory results. Additionally, it is found that the trapped air bubbles of the partially saturated samples act like a damping mechanism, which are reflected in the stress paths of the deviator stress q over the mean pressure p with an inclination of 1 : 3. Zum Verfl & uuml;ssigungsverhalten von teilges & auml;ttigtem SandDie durch Erdbeben verursachte Bodenverfl & uuml;ssigung ist ein verheerendes Ereignis, das die Fundamente von Geb & auml;uden und anderen Bauwerken gef & auml;hrden und zu erheblichen wirtschaftlichen Verlusten f & uuml;hren kann. Die induzierte partielle S & auml;ttigung (Induced Partial Saturation, IPS) gilt als eine der vielversprechendsten Technologien unter den neuartigen Baugrundverbesserungen gegen Verfl & uuml;ssigung. Um den Verfl & uuml;ssigungswiderstand und die Kompressibilit & auml;t der fl & uuml;ssigen Phase zu verbessern, werden dabei Gas- oder Luftblasen in das Porenwasser sandiger B & ouml;den eingebracht. Dieser Beitrag besch & auml;ftigt sich mit der generellen labortechnischen Evaluierung eines Sandes unter teilges & auml;ttigten Verh & auml;ltnissen und unter zyklischer Beanspruchung zur Beurteilung, inwiefern sich diese Baugrundverbesserung f & uuml;r den untersuchten Boden eignet. Die Verwendung der Axis Translation Technique zur Probenentw & auml;sserung und die Verwendung von diffusionsstabilen Butylmembranen haben einen erheblichen Einfluss auf die Laborergebnisse. Au ss erdem ist festzustellen, dass die eingeschlossenen Luftblasen der teilges & auml;ttigten Proben wie eine D & auml;mpfung wirken und sich in den Spannungspfaden der Deviatorspannung q & uuml;ber dem mittleren Druck p mit einer Neigung 1 : 3 widerspiegeln.

In this paper, a state-dependent, bounding surface plasticity model that simulates the behavior of unsaturated granular soils is presented. An unsaturated, soil mechanics-compatible elastoplastic response is adopted in which no part of the response occurs in a purely elastic fashion. To create an appropriate hydro-mechanical coupling, a newer generation stress framework, consisting of the Bishop-type effective stress and a second stress variable, is used in conjunction with a soil-water characteristic curve function. Details regarding the model development, parameter estimation, and assessment of the model's predictive capabilities are outlined. With a single set of parameter values, the model realistically simulates the main features that characterize the shear and volumetric behavior of unsaturated granular soils over a wide range of matric suction, density, and net confining pressure.