Mountain tunnels built near faults often suffer from significant permanent deformation and structural dislocation during seismic activity. In this paper, we present a rock-fault-tunnel geological model with a transition area between the hanging wall and the foot wall which allows the free slippery growth inside the area. A time-sequenced load based on design code and fault activity is conducted in this model to simulate dynamic seismic input after fault dislocation. In our case, a reverse fault with a tunnel cross has been created with this method. A 30cm fault dislocation is simulated by putting the displacement boundary of the hanging wall with a compression vector and the seismic wave is input from the bottom boundary as acceleration waveform adjusted to 0.4g. The model simulates the uplift of the hanging wall and the growth of the slip surface, and reveals the extension mechanism of the triangular shear zone of shear rupture of the surrounding rock due to the extrusion of the reverse fault during the propagation of the reverse fault. The seismic wave with a three-way acceleration was input after the dislocation process. The simulation indicates that with the gradual uplift of the hanging wall, the rock body of the fracture zone shows a more significant large deformation flow trend and a more significant horizontal slip flow. Under reverse fault thrust, the width of the shear effect influence zone is around 300m. A decreasing trend of accumulated strain can be found at the interface due to acceleration input. Dislocation-seismic time-sequence loading may underestimate its damage effects.