Poly(lactic acid) fiberwebs and multi-ply assemblies of nettle woven reinforcement are used to develop a series of nettle/PLA biocomposites with different reinforcement orientations. The tensile strength, flexural strength, impact strength, and thermal properties of the biocomposites are found to improve by piling nettle fabrics and are also found to depend strongly on the piling architecture and the test direction. It is possible to obtain a biocomposite with higher degrees of isotropy and enhanced mechanical properties by using cross-ply laminates. The threelayered woven fabric reinforced PLA biocomposite with a reinforcement orientation 0 degrees/45 degrees/90 degrees shows the best results among all the biocomposites developed in this study. The tensile strength, Young's (tensile) modulus, flexural strength, impact strength, storage modulus, and loss modulus of the biocomposite are found as 55.25 MPa, 6.30 GPa, 85.83 MPa, 63.74 J/m(2), 10.08 GPa, and 0.75 GPa, respectively. In this biocomposite, a fair adhesion between matrix and reinforcement is noticed, and this is justified by retardation of crack propagation as well as by substantial energy dissipation. The thermal stability of the biocomposite does not get effected much, but the percent crystallinity increases by 25.84%. The degradation kinetics and the activation energy of the biocomposite are determined through a differential fitting of Arrhenius model. The soil burial test reveals 15.06% of weight loss and 50.56% strength loss for this biocomposite just after 20 days of burial under soil.