By quantifying the absorption of black carbon (BC), brown carbon (BrC) and the lensing effect, we found that BrC dominates the total absorption at 450 nm, and the largest absorption contribution proportion of BrC could reach 78.3% during heavy pollution. The average absorption enhancement (E-abs) at 530 nm was only 1.38, indicating that BC is not coated well here. The average value of the absorption Angstrom exponent (AAE) between 450 nm and 530 nm was 5.3, suggesting a high concentration of BrC in Wangdu. CHN+ was the greatest contributor to the light absorption of molecules detected in MSOC with a proportion of 12.2-22.4%, in which the polycyclic aromatic nitrogen heterocycles (PANHs) were the dominant compounds. The C6H5NO3 and its homologous series accounted for 3.0-11.3%, and the C15H9N and its homologous series, including one C16H11N and three C17H13N compounds, accounted for 5.1-12.3%. The absorption of these PANHs is comparable to that of nitro-aromatics, which should attract more attention to the impact of climate radiative forcing.

Polycyclic aromatic hydrocarbons (PAHs) and their oxygenated (OPAHs) and nitrated (NPAHs) derivatives are main chromophores of the carbonaceous aerosol brown carbon (BrC), which is linked with radiative forcing. Here, we investigated the atmospheric absorption spectra of 64 PAHs, OPAHs, and NPAHs directly over the Chinese megacity of Xi'an, by employing a time-dependent density functional theory (TD-DFT) computational approach and correcting the results for the experimentally determined atmospheric concentration of the studied molecules. The obtained data showed that these molecules contribute more to radiative forcing by absorbing light in the UVA and (sub)visible region of the spectrum. Investigating daily absorption spectra revealed major seasonal variation in the intensity of light absorption, but little changes in the shape of the absorption spectra. The observed light absorption can be explained mainly by contributions from PAHs and to a lesser extent by carbonyl-OPAHs, with relatively low contributions of the other OPAHs and NPAHs. Among them, benzo[b+j+k] fluoranthenes, benzo[e]pyrene, benzo[a]pyrene, benzo[ghi]perylene, indeno[1,2,3-cd]pyrene, 6H-benzo[cd] pyren-6-one, 7H-benz[de]anthracen-7-one, and benz[a]anthracene-7,12-dione are highlighted as potentially problematic contributors for radiative forcing over Xi'an.

Brown carbon is a type of strong light-absorbing carbonaceous aerosol associated with radiative forcing. Nevertheless, the difficulty in correlating the chemical composition of brown carbon with its light absorption properties impairs the proper elucidation of its role in radiative forcing. Here, we have used a time-dependent density functional theory (TD-DFT)-based procedure to revisit the real-world absorption spectra of polycyclic aromatic hydrocarbons (PAHs) over the city of Porto, in Portugal, while correcting the spectra for their quantity in PM10 particulate matter. Our aim is to, by comparing these new results with those obtained previously regarding PM2.5 data, evaluate the role of different groupings of particulate matter in the light absorption of brown carbon. The results indicate that irrespective of the absorption spectra corresponding to their PM10 or PM2.5 data, the studied PAHs should contribute to radiative forcing by light absorption at UVA and (sub)visible wavelengths. However, the identity of the individual PAH species that contribute the most for the considered wavelengths can be quite different. Thus, different groupings of particulate matter appear to provide distinct contributions to light absorption and radiative forcing over the same location, even when considering the same class of molecular compounds.

Brown carbon is a type of carbonaceous aerosol with strong light absorption in the ultraviolet and visible wavelengths that leads to radiative forcing. However, it is difficult to correlate the chemical composition of brown carbon with its atmospheric light absorption properties, which translates into significant uncertainty. Thus, a time-dependent density functional theory (TD-DFT) approach was used to model the real-world absorption properties of 14 polycyclic aromatic hydrocarbons (PAHs) over three regions of the Basque Country (Spain): Bilbao, Urretxu, and Azpeitia. The data were corrected for atmospheric concentration. The results show that the absorption spectra over each region are qualitatively identical, with the absorption intensities being significantly higher over Bilbao than over Azpeitia and Urretxu. Furthermore, it was found that the light absorption by PAHs should be more relevant for radiative forcing when it occurs at UVA and (sub)visible wavelengths. Finally, among the 14 studied PAHs, benzo[b]fluoranthene, pyrene, fluoranthene, benzo[a]pyrene, and benzo[k]fluoranthene and benzoperylene were identified as the molecules with larger contributions to radiative forcing.

Aerosols affect the radiative forcing of the global climate and cloud properties. Organic aerosols are among the most important, yet least understood, components of the sensitive Tibetan Plateau atmosphere. Here, the concentration of and the seasonal and diurnal variations in biomass burning and biogenic aerosols, and their contribution to organic aerosols in the inland Tibetan Plateau were investigated using molecular tracers. Biomass burning tracers including levoglucosan and its isomers, and aromatic acids showed higher concentrations during winter than in summer. Molecular tracers of primary and secondary biogenic organic aerosols were more abundant during summer than those in winter. Meteorological conditions were the main factors influencing diurnal variations in most organic molecular tracers during both seasons. According to the tracer-based method, we found that biogenic secondary organic aerosols (38.5 %) and fungal spores (14.4 %) were the two dominant contributors to organic aerosols during summer, whereas biomass burning (15.4 %) was an important aerosol source during winter at remote continental background site. Results from the positive matrix factor source apportionment also demonstrate the importance of biomass burning and biogenic aerosols in the inland Tibetan Plateau. During winter, the long-range transport of biomass burning from South Asia contributes to organic aerosols. In contrast, the precursors, biogenic secondary organic aerosols, and fungal spores from local emissions/long-range transport are the major sources of organic aerosols during summer. Further investigation is required to distinguish between local emissions and the long-range transport of organic aerosols. In-depth insights into the organic aerosols in the Tibetan Plateau are expected to reduce the uncertainties when evaluating aerosol effects on the climate system in the Tibetan Plateau.

Black carbon (BC) deposited on snow lowers its albedo, potentially contributing to warming in the Arctic. Atmospheric distributions of BC and inorganic aerosols, which contribute directly and indirectly to radiative forcing, are also greatly influenced by depositions. To quantify these effects, accurate measurement of the spatial distributions of BC and ionic species representative of inorganic aerosols (ionic species hereafter) in snowpack in various regions of the Arctic is needed, but few such measurements are available. We measured mass concentrations of size-resolved BC (C-MBC) and ionic species in snowpack by using a single-particle soot photometer and ion chromatography, respectively, over Finland, Alaska, Siberia, Greenland, and Spitsbergen during early spring in 2012-2016. Total BC mass deposited per unit area (DEPMBC) during snow accumulation periods was derived from C-MBC and snow water equivalent (SWE). Our analyses showed that the spatial distributions of anthropogenic BC emission flux, total precipitable water, and topography strongly influenced latitudinal variations of C-MBC, BC size distributions, SWE, and DEPMBC. The average size distributions of BC in Arctic snowpack shifted to smaller sizes with decreasing C-MBC due to an increase in the removal efficiency of larger BC particles during transport from major sources. Our measurements of C-MBC were lower by a factor of 13 than previous measurements made with an Integrating Sphere/Integrating Sandwich spectrophotometer due mainly to interference from coexisting non-BC particles such as mineral dust. The SP2 data presented here will be useful for constraining climate models that estimate the effects of BC on the Arctic climate. Plain Language Summary Black carbon (BC) particles, commonly known as soot, are emitted from incomplete combustion of fossil fuels and biomass. They efficiently absorb solar radiation and thus heat the atmosphere. BC particles emitted at midlatitudes and in the Arctic are deposited onto snow in the Arctic, accelerating snowmelt in early spring by absorbing solar radiation. These processes contribute to warming in the Arctic. Calculations of this warming effect by using numerical models need to be validated by comparison with observed BC concentrations in snowpack. However, there are very few accurate records of concentrations of BC in snow because of technical difficulties in making these measurements. We developed a new laser-induced incandescence technique to measure BC concentrations in snowpack and applied it for the first time in six Arctic regions (Finland, Alaska, North and South Siberia, Greenland, and Spitsbergen). The BC concentrations we measured were highest in Finland and South Siberia, which are closer to large anthropogenic BC sources than the other regions, where our measured BC concentrations were much lower. On average, our BC concentrations were much lower than those previously measured by different techniques. Therefore, previous comparisons of modeled and observed BC concentrations need to be re-evaluated using the present data.

Brown carbon is a hotspot in the field of atmospheric carbonaceous aerosol research. It has significant influence on regional radiative forcing and exerts climatic effects due to its apparent absorbance in the near ultraviolet-visible region. Brown carbon is mainly derived from incomplete combustion of biomass or coal, as well as secondary sources, such as a series of atmospheric photochemical reactions from volatile organic compounds. Although the composition of brown carbon is complex, high-resolution mass spectrometry, with its ultra-high mass resolution and precision, enables elucidation of the characteristics of the organic components of brown carbon at the molecular level. Here, high-resolution mass spectrometry combined with traditional analytical methods was used for the study of brown carbon. The development of high-resolution mass spectrometry for brown carbon separation is reviewed, as well as compositional analysis, source apportionment, and formation mechanism of brown carbon based on high-resolution data. In addition, the issues and prospects for the application of high-resolution mass spectrometry to evaluate brown carbon are discussed.

Secondary organic aerosols (SOA), a subset of organic aerosols that are chemically produced in the atmosphere, are included in climate modeling calculations using very simple parameterizations. Estimates on their shortwave forcing on climate span almost two orders of magnitude, being potentially comparable to sulfate direct forcing. In the longwave, a neglected part of the spectrum when it comes to SOA, the direct SOA forcing could exceed that of sulfate and black carbon, although in absolute values, it is much weaker than the shortwave forcing. Critical for these estimates is the vertical distribution of the climate active agents, pointing to SOA temperature-dependent volatility. Over the last few years, research also revealed the highly oxidized character of organic aerosol and its chemical aging in the atmosphere that partially leads to the formation of brown carbon, an absorbing form of organic aerosol. This review summarizes critical advances in the understanding of SOA behavior and properties relevant to direct climate forcing and puts them in perspective with regard to primary organic aerosol and brown carbon. These findings also demonstrate an emerging dynamic picture of organic aerosol that has not yet been integrated in climate modeling. The challenges for the coming years in order to reduce uncertainties in the direct organic aerosol climate impact are discussed. High priority for future model development should be given to the dynamic link between white and brown organic aerosol and between primary and secondary organic aerosol. The SOA temperature-dependent volatility parameterizations and wavelength-dependent refractive index should be also included.

Observational evidence demonstrates that marine organic aerosols (MOA) are able to act as ice nuclei. MOA explains a substantial portion of the submicron marine aerosol, so that they have the potential to effectively influence marine cloud microphysics and cloud radiative forcing. This study provides the first evaluation of the radiative forcing and climatic impact of marine organic aerosols as ice nuclei on a global scale. MOA is implemented into a coupled aerosol and general circulation model. It is found that MOA contributes to more ice formation than dust or black carbon/organic matter in mixed-phase clouds. They also have a significant impact on the ice water path in the Southern Hemisphere and therefore could be an important missing source of ice nuclei in current models. The addition of MOA as natural heterogeneous ice nuclei reduces the magnitude of the total top-of-atmosphere anthropogenic aerosol forcing by as much as 0.3 W/m(2).