Microstructure and Wear Behavior of Ti-xFe-SiC in Situ Composite Ceramic Coatings on TC4 Substrate fromLaser Cladding

Titanium alloys are widely used in various structural materials due to their lightweight properties. However, the low wear resistance causes significant economic losses every year. Therefore, it is necessary to implement wear-resistant protection on the surface of titanium alloys. In this study, four types of in situ composite ceramic coatings with two-layer gradient structures were prepared on a Ti-6Al-4V (TC4) substrate using laser cladding. In order to reduce the dilution rate, a transition layer (Ti-40SiC (vol.%)) was first prepared on TC4 alloy. Then, a high-volume-fraction in situ composite ceramic working layer (Ti-xFe-80SiC (vol.%)) with different contents of Fe-based alloy powder (x = 0, 5, 10 and 15 vol.%) was prepared. The working surface of Ti-40SiC (TL) exhibited a typical XRD pattern of Ti, TiC, Ti 5Si 3, and Ti 3SiC 2. In comparison, both Ti-80SiC (WL-F0) and Ti-5Fe-80SiC (WL-F5) exhibited similar phase compositions to the TL coating, with no new phase identified in the coatings. However, the TiFeSi 2 and SiC phases were presented in Ti-10Fe-80SiC (WL-F10) and Ti-15Fe-80SiC (WL-F15). It is proven that the addition of the Fe element could regulate the in situ reaction in the original Ti-Si-C ternary system to form the new phases with high hardness and good wear resistance. The hardness of the WL-F15 (1842.9 HV 1) is five times higher than that of the matrix (350 HV 1). Due to the existence of self-lubricating phases such as Ti 5Si 3 and Ti 3SiC 2, a lubricating film was presented in the WL-F0 and WL-F5 coatings, which could block the further damage of the friction pair and enhance the wear resistance. Furthermore, a wear-transition phenomenon was observed in the WL-F10 and WL-F15 coatings, which was similar to the friction behavior of structural ceramics. Under the load of 10 N and 20 N, the wear volume of WL-F15 coating is 5.2% and 63.7% of that in the substrate, and the depth of friction of WL-15 coating is only 14.4% and 80% of that in the substrate. The transition of wear volume and depth can be attributed to the wear mechanism changing from oxidation wear to adhesive wear.

成果名称:低表面能涂层

合作方式:技术开发

联 系 人:周老师

联系电话:13321314106

成果名称:低表面能涂层

合作方式:技术开发

联 系 人:周老师

联系电话:13321314106

成果名称:低表面能涂层

合作方式:技术开发

联 系 人:周老师

联系电话:13321314106

成果名称:低表面能涂层

合作方式:技术开发

联 系 人:周老师

联系电话:13321314106

润滑集